Flush mounted LED back-up light for use with Poison Spyder Customs Crusher Corners, Trail Corners or any other manufacturer's corner protectors, or anywhere you can cut a hole in a flat sheetmetal panel. push-in mounting with the included rubber grommet. Sold by each, if you need a pair specify a quantity of 2.
I have the Rockbrawler bumper. These lights were supposed to fit in the holes on the bumper. Cannot get them in. Please provide video on installation or instructions.
from Denton, TX
4.0Very tight fit
Very difficult to install even after heating up the rubber grommet in 150F water and using WD-40. I question the dimensions and interference fit between the grommet and light OD.
1.0Lights into bumper....
Lights seem to be a good quality product but impossible to fit them into my RockBrawler bumper, recommended product by Poison Spyder so expected them to work. The Poison Spyder video associated with the lights only shows installation into a rear quarter which I’m sure is simple, they need to show how to get them into this bumper.
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now