Designed with the off-roader in mind, Pro Comp’s new Rock Lights utilize waterproof aluminum LED housings for safe and reliable performance in all weather conditions. Each of the six white Rock Light circuits is fitted with 3 x 3W CREE LEDs with long leads to allow you to mount the LED’s in a variety of locations depending on your application for greater versatility. Includes hardware and wiring instructions.
The lights are great but the wiring is way too short, only 5 feet for each light!!
Just Perfect I could not ask for anything more , and for $ 89 Bucks you can’t go wrong .
from Washington State
This is nice kit. App is easy to use. The reason I didn't give it 5 stars is because they need better directions and a way to shorten up the wires because I think it looks sloppy with all the wires bundled up with zip tie wrapped around it!
5.0Great lights for the price
Great lights for the price. I put 1 in each front and rear wheel well so I can see clearance.and 1 on my rock sliders underneath on each side. Wiring was not bad. Really nice at night in the desert. Helps avoid rocks clearance areas and tumble weeds. Very cool for any application.
from Fontana CA
Great lights I ran them with a relay, 1 light in the rear wheel well and one under my Rock sliders close to the frame and one up front under the front wheel well 3 on each side ran the wire from rear to front, rear wired into the middle light And middle light to front light , ending up with two wires to the relay, solder the wires using shrink wrap for a clean install, or you could use solderless bullet connectors but get the shrink connectors and use dielectric grease when connecting them. Plenty bright enough for night Running.
from Eastern Washington
5.0Lights up the ground!
Easy install, only took a few hours. But wish I had 2 more lights included. But very pleased!
Please contact Pro Comp's customer service to help trouble shoot this for you: 800-776-0767
from 4WP Corporate Headquarters
Do these include all the wiring needed for the installation? Do they all get wired into 1 control box?
Answer this question
Yes. I wired these up to a 88 FJ62 and there was plenty of wire to go from each light to the engine bay, which is where I crimped them all together with the supplied crimps. I then carried the wire over to an auxiliary fuse block and switch inside the cab. Install was easy, however these lights are not as bright as they advertise.
Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now